Opto Engineering® LTDVE series of controllers can be configured via Ethernet or RS485. With the Ethernet interface, you can configure the controller with either the Modbus/TCP slave protocol or the internal web browser. The second option allows for a very easy configuration of the controller using a common web browser to visually change the parameters and/or inspect the device status. Easily set the output current intensity of each connected illuminator in small steps (0.2mA, 4mA or 20mA depending on current range) Set the pulse duration and pulse delay of each illuminator in small steps as low as 1μs Control the connected illuminators with up to 8 synchronization inputs Control up to 8 synchronization outputs (e.g. up to 8 cameras) Write and save different configurations depending on your application The LTDVE series can also be configured via the RS485 communication port interface that implements the Modbus/RTU slave protocol. The configuration is stored in a non-volatile memory to maintain your settings even when the Ethernet or RS485 connection is removed.